Magic Chef MCSBRG24W, Installation Manual

14

HOW TO CONNECT ELECTRIC POWER

W

ARNING: 

Electrical Shock Hazard

• 

Plug into a grounded 3 prong outlet�

• 

DO NOT remove the ground prong from the power cord plug�

• 

DO NOT use an adapter�

• 

DO NOT use an extension cord�

• 

Failure to do so can result in death, fire, or electrical shock�

IMPORT

ANT: 

For personal safety, this appliance must be properly grounded.

Electrical Require

ments

• 

A 120 volt, 60Hz�, AC only 15-amp fused, electrical circuit is required� A time delay fuse or circuit breaker is 
also recommended� It is recommended that a separate circuit serving only for this range is provided�

• 

Electronic ignition systems operate within wide voltage limits, but proper grounding and polarity are 
necessary� Check that the outlet provides 120-volt power and is correctly grounded�

• 

This range is not required to be plugged into a GFCI (Ground-Fault Circuit Interrupter) outlet� It is 
recommended that you DO NOT plug an electric spark ignition gas range or any other major appliance into 
a GFCI wall outlet as it may cause the GFCI to trip during normal cycle�

• 

Performance of this range will not be affected if operated on a GFCI-protected circuit� However, occasional 
nuisance tripping of the GFCI break is possible due to the normal operating nature of the electronic gas 
ranges�

NOTE

: The metal chassis of the range must be gr

ounded� If the metal chassis is not grounded, the control panel 

will not operate� Check with a qualified technician to ensure the metal chassis of the range is grounded properly�

Steps to Connect Electric Power

1� 

Slide Range close to final location�

2� 

Plug into a grounded 3 prong outlet�

HOW TO INST

ALL RANGE TO FINAL LOCATION

IMPORT

ANT: 

If the range is moved to adjust the leveling legs, make sure when placing the oven back into its 

final place that the anti-tip bracket is engaged�
1� 

When sliding the range into its final location ensure the rear leveling legs slide into the anti-tip bracket�  

2� 

Place the outside of your foot against the bottom of the front of the range to keep the range from moving, 
and then grasp the back of the range�

3� 

Slowly attempt to tilt the range forward� Use caution when tilting the range forward�

4� 

If the range lifts more than 1/2” (1�3cm) off the floor without resistance, stop tilting the range and lower it 
gently back to the floor� 

IMPORTANT

: If you hear a snapping or popping sound when lifting the range, the range may not be fully 

engaged in the bracket� Check the bracket for obstructions keeping the range from sliding into the wall or keeping 
the range foot from sliding into the bracket� Verify that the bracket is held securely to the mounting screws�
5� 

Slide the range forward to verify the anti-tip bracket is securely attached to the floor�

6� 

Slide range back so the rear foot is inserted into the slot of the anti-tip bracket�

7� 

Repeat steps 1 and 2 to ensure that the range foot is engaged in the anti-tip bracket�