11
EN - 11
AUTOMATIC DEFROST
• The ice build-up on the inner back wall during compressor operation will be
automatically defrosted in a compressor off cycle.
• When defrosting is in process, the indicators for both zones will go off, and the
circulation fans for both zones will run.
• Each zone has its own drip pan placed at the bottom against the rear wall (see Parts
on page 4).
• Defrost water will drain into the drip pans. Water accumulated in the drip pans
should be discarded periodically. It is recommended to empty the drip pans every
second or third week.
Cleaning Your Appliance
• Upon installation of your new appliance, it is recommended that it be cleaned
thoroughly. Unplug the unit from the wall outlet and remove all contents.
• Wash the inside with a damp warm cloth soaked in lukewarm water and baking
soda solution. The solution should be about 2 tablespoons of baking soda to a quart
of water. Be sure to keep the door gasket (seal) clean to keep the unit running
efficiently. The outside of the appliance should be cleaned with mild detergent and
warm water. Dry the interior and exterior with a soft cloth. Dust or anything else
blocking the vent may hinder the cooling efficiency of the appliance. Vacuum the
vent if necessary.
Vacation Time
•
Short vacations
: Leave the appliance operating during vacations less than 3 weeks.
•
Long vacations
: If the appliance will not be used for 3 weeks or more, remove all
content and unplug the power cord. Clean and dry the interior thoroughly. To
prevent odor and mold growth, leave the door open slightly.
Moving Your Appliance
• Unplug the unit from the wall outlet, and then remove all contents. Securely tape
down all loose items inside your appliance. Lastly, tape the doors shut.
Energy Saving Tips
• The appliance should be located in the coolest area of the room, away from heat
producing appliances or heating ducts, and out of direct sunlight. Ensure that the
door is closed when the appliance is plugged in.
CARE AND MAINTENANCE
