31
11.7 PROBLEMS WITH COIN ACCEPTORS/BILL ACCEPTORS
1. Possible problems with acceptors firmware
2. Check wirings for acceptors
3. No USB connection between I/O board and computer
4. Try to restart your machine
11.8 BUTTONS/COINS MECH NOT WORKING
1. Check wiring connections to I/O board
2. If new CPU board, I/O board installed you will be asked to confirm USB Access permission to USB device.
Check everything as described on picture below. Check use by default[...]
→ click OK. Often three times this
pop-up occur.
4.
If You accidently press CANCEL after selecting checkbox for „Use default...“
reconnect USB device.
11.9 SYSTEM RECOVERY for CPU board v3
We are adding special USB auto-restore flash drive to every Timberman machine.
ATTENTION!
This flash drive WILL AUTOMATICALLY ERASE WHOLE COMPUTER HARD DISK, ALL MACHINE DATA WILL BE
LOST!
DO NOT CONNECT AND BOOT IT IN NORMAL COMPUTER!
If you replace hard disk or if you encounter system boot failures there is an ease way to recover your
machine to factory state using this USB auto-restore backup.
You need only usb keyboard and the auto-restore usb flash drive. If you lost it, please contact your
distributor for instructions.
Procedure:
1. Turn OFF your machine
2. Connect keyboard and USB auto-restore flash drive to free USB ports of machine computer
3. Turn ON your machine
4. Immediately push multiple times F12 keyboard button till you will see „Please select boot device” pop-
up window. ATTENTION: Some screens may not display this dialog box, you will see „No signal” pop-up.