Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity.
10
MGC LSH 3 R - 080308
Assembly page 10/32
Fax +32 2 359 95 50
•
Remover the protective cap.
•
Insert the plug of the adaptor in the appliance (the charging indicator lights up) or use the
appliance without adaptor if you have charged it beforehand.
•
Plug the adaptor in the power socket.
•
Switch on the appliance by sliding the switch to the desired setting. Use setting 1 to epilate
soft hair and setting 2 to epilate tough hair. During use, the charging indicator will go out
and the lamp for lighting will go on.
•
For a better result, move the appliance against the grain of the hair and place the
appliance with the switch facing away from you. For the legs, move upward.
•
Position the appliance so that it is vertical against your skin, at a 90° angle. To soften the
epliation you can slightly press the outlines of the surface you want to treat with your
fingers.
•
Replace the protective cap on the head after use and unplug the adaptor.
Note: It is possible to epilate the armpits, the groin and above the lips, but these are more
delicate surfaces and some people might experience some discomfort when treating these
zones.
B)
Shaving function
•
Remove the epilation head if it is on the appliance. To do so, press the release button of
the heads and pull at the head.
•
Attach the shaver head on the unit of the appliance by pressing till it clicks. Make sure you
attach the head correctly. The small toothed wheel of the head must correspond to the
toothed wheel on top of the unit of the appliance.
•
Remover the protective cap.
•
Insert the plug of the adaptor in the appliance (the charging indicator lights up) or use the
appliance without adaptor if you have charged it beforehand.
•
Plug the adaptor in the power socket.
•
Switch on the appliance by sliding the switch to setting number 2 (setting number 1 is not
appropriate for the shaving function).
•
If the hairs are longer than 10 mm we advise you to use the long hair trimmer first and to
shave afterwards.
•
Position the long hair trimmer horizontally against the skin and move it against the grain of
the hair.
•
Position the shaver head so that it is vertical against your skin, at a 90° angle and press the
protective grate against the skin. Move it against the grain of the hairs.
•
Replace the protective cap on the head after use.
MAINTENANCE
Always unplug the appliance before cleaning.
A regular cleaning of the heads prolong their life span and improves their efficiency. Do not
clean the heads with water as the hairs would stick to them instead of being removed.
•
To clean the epilation head, first remove the disc housing by pressing on the release
button and by gently pulling on each side of the head at the same time. Use the brush
provided to brush out small hairs that have accumulated between tweezer discs and
inside the disc housing. It is possible to turn the discs manually to facilitate cleaning. As the
discs are not sharp, it is not dangerous. Do not forget to replace the head on the
appliance after cleaning.
