Setup
1
Card Stacker
1
Hook the tab of the card stacker that is supplied
with the card printer to the card stacker attachment
slot
A
B
D
C
Card outlet
Card stacker attachment slot
Tab
Card stacker
Power Cord Connection
1
Insert the power cord (supplied) to the AC inlet at
the rear of the laminator
2
Plug the power cord (supplied) into an outlet
INLET
INLET
OPTION
Cautions:
Make sure that the power outlet is grounded and used as
a dedicated power source for the laminator. Make sure
that the power cord is inserted directly into the outlet, and
do not share with other devices.
Memo:
Make use of an AVR (automatic voltage regulator)
to prevent any fluctuation in voltage. Alternatively, an
uninterruptible power supply is recommended in case
momentary power outage occurs.
A
B
C
D
●
●
Setting Laminate Film
Attach a patch film or overlay film on the film cassette.
The film type is set to patch film by default. When using
overlay film for the first time after purchasing the laminator,
turn on the laminator and the card printer and change [Film
Type] of the laminator to [Overlay] on the status monitor
before removing the cassette to load the film.
This laminator selects the side of the card to be laminated
by the presence of the film cassette. Load the film cassette
to the side of the card to be laminated.
Cautions:
If the security lock of the card printer is on, deactivate it.
After work is complete, activate the security lock again.
For details on locking/unlocking the security lock, refer to
the manual of the card printer.
Stand the film cassette on a flat surface. Avoid doing so
on a floor as dust attached to the film may cause poor
adhesion or malfunction.
A film cassette that has laminate film attached on it is
heavy. Hold the film cassette with both hands to avoid
dropping when working with it.
If the laminate film is attached in the wrong direction, film
detection error or lamination defects may occur. Attach the
laminate film in the right direction.
Match the loaded laminate film with the [Film Type] setting.
If the laminate film and the setting do not coincide, film
detection error occurs after the laminate film has been
forwarded for a certain length.
In the case of single-sided lamination, an error will occur
if a film cassette that is not loaded with laminate film is
attached to the side that is not to be laminated. Remove
the film cassette from the side that is not to be laminated.
For double-sided lamination, ensure that both the top side
and bottom side film cassettes are attached. The absence
of film cassette on either side will result in single-sided
lamination.
For double-sided lamination, use the same type of
laminate film for the top side and bottom side. Using
different types of laminate film may result in card jam or
error.
1
Open the laminator door
●
●
●
●
●
●
●
●
●
●
●
