1
2
Press and hold down the cassette button, and pull
out the film cassette
3
Attach the tip of the new laminate film to the bobbin
Place the new laminate film and the take-up bobbin side
by side on a clean and flat platform.
Attach the tip of the new laminate film to the take-up bob-
bin using the fixing tape.
Use the fixing tape after peeling off
the adhesive label of the laminate
film.
Cautions:
Attach the laminate film to the take-up bobbin such that
they are parallel to each other.
Otherwise, it may result in poor adhesion or cause film
detection errors.
4
Install the new laminate film on the film cassette
Install while referring to the indication on the label of
the cassette.
Top Side Film Cassette
Bottom Side Film Cassette
Insert the supply side of the film into the bobbin holders
(patch position adjustment mechanism attached).
Unwind the laminate film along the film guides, and insert
the take-up side into the bobbin holders.
A
B
●
●
A
B
Top Side Film Cassette Bottom Side Film Cassette
C
Wind the film twice around the take-up side.
Top Side Film Cassette Bottom Side Film Cassette
5
Remove any slack in the laminate film
6
Insert the film cassette all the way in along the
guide rail until a “click” sound is heard, and close
the laminator door
Cautions:
Make sure to insert the film cassette all the way in until
a “click” sound is heard. Failure to do so may result in
defective patch or card jam.
If the film cassette is inserted upside down, it cannot
be inserted all the way in and the cassette button does
not lock in place. Also, you will not be able to close the
laminator door.
●
●
Orange
Yellowish-
green