Laminate Film
This laminator selects the side of the card to be laminated
by the presence of the film cassette. Load the film cassette
to the side of the card to be laminated.
Cautions:
If the security lock of the card printer is on, deactivate it.
After work is complete, activate the security lock again.
For details on locking/unlocking the security lock, refer to
the manual of the card printer.
Stand the film cassette on a flat surface. Avoid doing so
on a floor as dust attached to the film may cause poor
adhesion or malfunction.
A film cassette that has laminate film attached on it is
heavy. Hold the film cassette with both hands to avoid
dropping when working with it.
If the laminate film is attached in the wrong direction, film
detection error or lamination defects may occur. Attach the
laminate film in the right direction.
Match the loaded laminate film with the [Film Type] setting.
If the laminate film and the setting do not coincide, film
detection error occurs after the laminate film has been
forwarded for a certain length.
In the case of single-sided lamination, an error will occur
if a film cassette that is not loaded with laminate film is
attached to the side that is not to be laminated. Remove
the film cassette from the side that is not to be laminated.
For double-sided lamination, ensure that both the top side
and bottom side film cassettes are attached. The absence
of film cassette on either side will result in single-sided
lamination.
For double-sided lamination, use the same type of
laminate film for the top side and bottom side. Using
different types of laminate film may result in card jam or
error.
1
Open the laminator door
●
●
●
●
●
●
●
●
●
2
Remove any slack in the laminate film
Turn the knob on the film cassette in the direction
indicated by the arrow.
3
Press and hold down the cassette button, and pull
out the film cassette
4
Remove the laminate film from the film cassette
●
Replacement