Troubleshooting
18
Troubleshooting
If you experience any difficulties, please refer to the troubleshooting steps below.
1. Turntable will not turn on
• The power plug is not connected. Connect the power plug to the wall outlet.
2. No sound
• Please check if the volume is set too low and adjust the volume.
• The input selector is set to the wrong mode. Select the correct input mode.
3. Noise or distortions during playback
• The Turntable is too close to another electronic device. Place the Turntable in
another position.
• The distance to the external Bluetooth device is further than 33 ft. (10 m). Re-
duce the distance between Turntable and external Bluetooth device.
4. Turntable does not respond
• This may be caused by electrostatic discharge. Disconnect the Turntable power
plug. Wait for approximately 5 minutes, reconnect the power plug and then turn
on the Turntable.
5. No sound output while an external AUX device is connected
• The AUX cable is not connected properly. Check the AUX cable connecting the
Turntable and the external AUX device.
• The wrong mode is selected on the Turntable. Select the AUX mode.
6. No sound output while a Bluetooth device is connected
• The wrong mode is selected. Set the Autostop to “ON” to set the Turntable to
the Bluetooth mode.
• The volume on the Turntable or the external Bluetooth device is too low. Turn
up the volume on the Turntable and/or the external device.
• The distance to the external Bluetooth device is further than 33 ft. (10 m). Re-
duce the distance between the Turntable and the external Bluetooth device.
• If the above steps do not help, try to pair both devices again.
7. The external Bluetooth device cannot be paired with the Turntable
• The external device has no Bluetooth function. Read the manual of the exter-
nal device to make sure it is compatible with the Bluetooth function.
• The Bluetooth function of the external device is disabled. Pair the Turntable
and the external device again.
• The external device is paired with another device. Disconnect from the paired
device. Try to pair the Turntable and the external device again.
• Make sure the Autostop is “ON”