EN
39
2�3 Safety during Assembly
Always observe the safety instructions in sections 1.1 to 1.5 when
installing and connecting the unit to avoid damage to the device
and life-threatening situations.
Also observe the following safety instructions:
• Switch off the machine during all work and disconnect
any power
• Do not install the device in areas where there is a risk of gas
or dust explosion, in wet rooms or wet areas
• The device is not intended for outdoor use, always mount it
protected from the weather
• Make sure that the cable cross-section is sufficient
• Lay the cables in such a way that they cannot be damaged
by doors, windows or otherwise
• Crushed cables can lead to life-threatening injuries
• During operation the device generates dangerous voltages.
Always make sure that all safety instructions are observed
• Lay the cables in such a way that there is no risk of tripping
and damage to the cable can be excluded
• Make sure that you stand securely. The device must be
mounted so that it stands securely. It must not be able to fall
over, slide or fall down
• Install the device out of the reach of children
• Never open the device!
• Never lay the 230 V output cable and DC supply cables
together in the same cable duct!
• Use empty conduits or cable bushings if cables must be
routed through sheet metal walls or other sharp-edged walls
• Do not lay the direct and alternating current cables in the
same cable duct/empty conduit
WARNING
CAUTION
ATTENTION
