52
6�4 Overload Protection
If the required continuous power is above the specification,
the inverter automatically switches off the 230 V AC output.
The red LED flashes slowly. The inverter releases the output
again as soon as the fault has been rectified.
!
Note performance!
The overload protection only applies to
continuous
power – not to peak power. If the peak power is
exceeded, the device will be damaged
6�5 Output Short Circuit
If a short circuit occurs at the 230 V AC output, the inverter
automatically switches it off.
The red LED flashes slowly. The inverter releases the output
again as soon as the fault has been rectified.
7 Troubleshooting
Problem
Possible Cause
Troubleshooting
The device be-
eps loudly and
continuously
Undervoltage protection acti-
ve soon
Charge the battery
The green „Pow-
er“ LED
A
lights
up but connec-
ted devices do
not start
The battery power is too
low or the battery level is
too low to deliver the requi-
red performance
Use batteries with a higher
capacity.
Check the condition of the
battery.
Charge the battery
Bad connection
between inverter and
battery
Check all connections
and connecting points
