1-800-MAGLINE (624-5463)
Page 13 www.magliner.com
CooLift
®
REPLACING FRONT WHEEL
TOOLS NEEDED: PLIERS
Caution: Remove and replace only one roller at a time.
1)
With the cart sitting on a level flooring surface and the holding brake engaged, remove the cotter pin, washers and
roller.
2) Replace with new roller and washers as shown below. Install cotter pin and bend the ends to hold in place.
A
B
C
B
D
Item
Qty.
Part
Number
A
Cotter pin - 1/8” x 1-1/2” long
1
81078
B
Washer
2
80723
C
Front wheel
1
130014
D
Front axle - 13” long
1
309844
Quantities listed are for each front roller
REPLACING REAR SWIVEL CASTER
TOOLS NEEDED: TWO 9/16” WRENCHES
Caution: Remove and replace only one caster at a time.
1)
With the cart sitting on a level flooring surface, the holding brake engaged and the rear access panel removed,
remove the battery(ies).
2) Loosen the three screws that hold the caster mount to the base of the cart using the pair of 9/16” wrenches.
3) The entire rear swivel caster assembly can now be lowered and slid out of position.
4) Position the replacement rear swivel caster in place and insert the three screws through the base of the cart and
fasten with lock nuts against the swivel caster mount using the pair of 9/16” wrenches.
5) Replace back access panel.
A
C
Item
Qty.
Part
Number
A
Hex head cap screw - 3/8”-16
x 1-1/4” long
3
80026
B
Hex lock nut flange - 3/8”-16
3
80624
C
Caster assembly - 6” x 2”
swivel grey flat tread
1
130066
Quantities listed are for each rear swivel caster
B