1-800-MAGLINE (624-5463)
Page 35 www.magliner.com
CooLift
®
12) Place the leaf spring onto one of the brake pads so that the spring feet are on either side of the
pad material (see Figure 3).
13) Place the opposing pad onto the leaf spring so that the spring feet are on either side of the pad
material.
14) Pinch the pad tabs together so that the pad material on both pads are touching.
15) Slide pads and leaf spring into the top window of the caliper until they come to a stop (see
Figure 5). Using a 2.5mm Allen wrench install and tighten the pad retaining pin. Pad pin torque
should be 10 +/- 1 in.-lbs.
16) Position the caliper (C) within the caliper mount and lightly hand tighten the mounting screws (A)
(Figure 4). NOTE: Do not use the wrench on them until the caliper has been aligned or damage
to the brake disc could result.
17) Engage the holding brake.
18) With the caliper mounting bolts lightly hand tightened and the holding brake engaged, the
caliper will correctly self position its orientation relative to the brake disc.
19) Tighten the caliper mounting screws (A) with the 5mm Allen wrench.
Item
Qty.
Part Number
A Hex socket head cap screw - M6 x 20mm
2
80003
B Pair of brake pads
1
309594
C Caliper assembly
1
309595
Compressing the piston
A
Figure 1
Figure 2
Quantities listed are for one side of the CooLift
C
Figure 4
Inserting the pads
B
Figure 3
Assembling spring to pads
Figure 5
