1-800-MAGLINE (624-5463)
Page 54 www.magliner.com
CooLift
®
The brakes are not working or braking unevenly side to side.
Do you see any leaks in the brake system?
Is the brake fluid level correct in the reservoir?
Are both of the calipers mounted tightly to the rail?
If you pump the brake lever several times, does it start working?
Check to see that the discs are running true and mounted properly.
Check to see if disc mounting screws have not backed out.
Contact Magline if problem persists.
The pump runs and will not shut off.
Turn off main power switch.
Check the continuity of the starter solenoid.
Check the continuity of the operator on/off switch.
Hydraulic or brake fluid has dripped into the drip pan underneath the CooLift deck.
Wipe up any fluid that may have leaked into the drip pan using shop towels.
Brake fluid has dripped into the drip pan underneath the CooLift deck.
Check for leaks in the brake system and tighten loose components, or repair any damaged
components.
Wipe up any fluid that may have leaked into the drip pan using shop towels.
Contact Magline if problem persists.
The propulsion assist feature is not operating.
Have the batteries been charged?
Are both the lift system and propulsion system switches turned to the ON position?
Fully lower the deck and turn both the lift system and propulsion system switches to the OFF
position. Wait 2-3 minutes and turn the lift system and propulsion system switches to the ON
position.
Have you pressed the throttle interlock button before using the throttle?
Are the wires to the interlock and throttle connected? Both in the enclosure and on the
handle?
Check the chains in the propulsion system to see if they are in place and tensioned properly.
Has the parking brake been released?
Check for loose wire connections from the controller or battery.
Is there any debris in the chains or in other parts of the propulsion system?
Contact Magline if problem persists.
