1-800-MAGLINE (624-5463)
Page 50 www.magliner.com
CooLift
®
REPLACING BRAKE PAWL
TOOLS NEEDED:
5/16” WRENCH
#2 PHILLIPS
MEDIUM FLAT HEAD SCREW DRIVER
MEDIUM STRENGTH THREAD LOCKER (BLUE)
Note: It is important to keep the CooLift upright at all times.
1. Pull the brake lever back approximately 1/2” to 3/4” and secure it in place using a heavy duty
cable tie (Figure 1).
2. Figure 2 shows the three holes that will be utilized with the new brake pawl assembly.
Remove the self-locking retaining clip that holds the current pawl in place by prying it off with a
flat screwdriver. Pull out the pin to remove the spring and the pawl, taking care to keep track
of the spring as it will be used within the new assembly.
3. Place the spring inside the new pawl (B) as illustrated in Figure 3 and slide it in place over
the end of the brake lever and secure with the screw, flat washer and locknut provided
(C,D,E); tighten to minimize L-R movement with free rotation. Test the spring action after the
installation (it should react in the same way the old pawl did).
Figure 1
Figure 2
Figure 3
C,D,E
F,G
Item
Description
Qty.
Part Number
Brake Pawl Kit (includes all items below)
309219
A
Master cylinder U-bracket
1
309182
B
Brake pawl for master cylinder
1
309183
C
Pan head machine screw - #10-32 UNF x 1” long
1
80123
D
Flat washer for #10 screw
1
80763
E
Hex lock nut 10-32UNF thread
1
80684
F
Round head machine screw - #10-32 UNF x 7/8” long
2
80122
G
Lock washer split for #10 screw
2
80747
H
Cable tie
2
61052
H
