Magma
EB3600-P | Chapter 4 Express I/O Manager
79
Reset the chassis to default parameters
Restore your chassis to the factory default values by pressing front button 10 time continuously . When all
values have been restored, the expansion will shut down and reboot back up.
Below are steps on how to reset the chassis to default parameters / values.
A.
Turn OFF the Host computer.
B.
Turn OFF the expansion unit.
C.
Disconnect the expansion unit from the Host computer.
D.
Turn ON the expansion unit.
E.
Press the front “Button” (a.k.a Power On Button / Front LED)
ten times
continuously.
F.
The expansion unit will shut down and reboot back up. If it doesn’t power up, press
the front button to power it up.
G.
Start your Internet Browser
a.
Type 192.168.1.10
b.
Enter User name: Admin
c.
Enter password: magma
d.
You should be able to login. Check, the SNMP make sure it is set back to
default configuration.
Configure your SNMP Agent
If you use an SNMP agent to help you monitor your network, you will find all necessary monitoring
information in the MIB file.
Summary of Contents for ExpressBox EB3600-P
