Magma
EB3600-P | Chapter 4 Express I/O Manager
73
a.
For IP address enter 192.168.1.20
b.
For Subnet mask enter 255.255.255.0
7.
Click OK
How to configure your network setting in Linux / Ubuntu
1.
Start or launch the Terminal window.
2.
Stop Network Manager by typing
service NetworkManager stop
command in the terminal.
3.
Type
sudo ifconfig eth0 192.168.1.40 netmask 255.255.255.0
( see screenshot below).
4.
Type
route add default gw 192.168.1.1
5.
Then press enter to accept the new settings.
6.
You need to restart the network by typing
service network restart
command in the terminal.
7.
Type
ifconfig
, to check and verify that the new IP address and Subnet mask have been accepted
(see screenshot below).
Summary of Contents for ExpressBox EB3600-P
