M A G M A
12
Chapter 4 Install 3rd Party PCI Cards
PCI slots
Power Supply
Fan assembly with slot holders for full-length cards
Drive bay – used to mount up to eight (8) 3.5” internal hard drives
using 1 or 2 optional Disk Drive Cages (PN: RDRIVECAGE)
5V load resistor – to be removed if optional hard drives are installed
IMPORTANT
The sheer number of PCI cards and device drivers available
makes it impossible for Magma to fully test and certify all available
PCI cards for use in the Magma expansion chassis. Our best
advice to you in this regard is to insist on full PCI Specification
compliance from your card and system vendors. Cards and
systems should be at least PCI Specification Revision 2.0
compliant or better. Compliance in your system motherboard, PCI
cards, and console firmware (or BIOS) is your best assurance that
everything will install and operate smoothly.
Not all PCI cards are as "well-behaved" as they should be.
Sometimes simply moving a PCI card that is having a problem to a
different slot, or reordering your cards in their slots, will alleviate
"behavior" problems.
Install Hard Drive(s)
Installing Hard Drives
Installing up to seven (7) hard drives into your 7-Slot chassis, or four (4) in your
13-Slot Chassis, is simple using one or two optional Drive Cages (PN:
RDRIVECAGE), available from Magma. Each cage can hold up to four (4) 3.5”