Magna-Matic MAG-200 Series Original Instructions Download

Page: 2 / 2

Installing the **OPTIONAL** 200-20 Stand Mounting Brackets for

hanging the MAG-200 on the MAG-10400 Stand

1. Remove the yellow bottom cover

2. Remove the 5/16-18 bolts and nuts from the MAG-200 body. These bolts/nuts act as

plugs if the brackets are not installed.

This hardware is used to connect the brackets to the MAG-200.

3. The brackets interlock - make sure the hook end is pointing downward.

4. The long support bracket fits on the inside to make the bottom bracket more rigid, this

bracket shares two #10 screws from the body.

5. Mount the other two brackets on the MAG-10400 stand, with the hooks facing upward.

6. The hooks will interlock and allow the MAG-200 to hang on the MAG-10400 stand

or other surface.

Best Placement for MAG-200

Typically the best placement on the stand for the MAG-200

is on the right side of the stand as shown in the two

images. This way the hose is out of your way when

sharpening or balancing lawn mower blades. It also

provides the best access to the ON/OFF switch.

200-20-Kit

Magna-Matic Corporation - W4599 County Road IW - Waldo WI 53093 USA

Phone: (920) 564-2366 - FAX: (920) 564-2368 - Toll Free USA & Canada

1-800-328-1110

http://

www.magna-matic.com

Summary of Contents for MAG-200 Series

Page 1: ...200 to block all incoming large grit and sparks from the pad filter 4 Install the yellow bottom cover back onto the MAG 200 Pad Pleated Filter Cleaning While both of these filters are designed to be d...

Page 2: ...the body 5 Mount the other two brackets on the MAG 10400 stand with the hooks facing upward 6 The hooks will interlock and allow the MAG 200 to hang on the MAG 10400 stand or other surface Best Place...