BLUEPIRAT2 | USER MANUAL/
page 46 of 82
Cable sets
When inserting the cable sets in the usual case, only a slight force is required. At an increased
mechanical resistance during insertion of the cable set, the correct alignment of the pins should
be checked.
Special cable sets are to be manufactured strictly according to the sheet of the instruction man-
ual containing the pin assignment, whereby an extra fuse provided on the cable set must be
considered. The connectors specified in the instruction manual should be used.
The cable sets’ temperature range is restricted to -20°C to +70°C due to the banana plugs.
Only valid for the power supply connection of the BLUEPIRAT2, not BLUEPIRAT2 5E:
Three of the pins are assigned to only one type of electrical potential, that means an intercon-
nection to positive electrical potential (Klemme 30/Clamp 30) for one group comprised of the
three related pins and the negative one (Klemme 31/Clamp 31) for the other group consisting of
three matching pins.
Warning:
However a conductive connection of the three connected pins with two different electri-
cal polarities results in short circuiting and destruction of the device in case of a missing
suitable fuse.
Mounting
In laboratory setups and automobiles the units must be attached in such a way, that it is en-
sured against dropping, slipping and skidding.
Positioning of the antenna
While operating the device in an automobile, the connected antennas must not be located out-
side of the vehicle.
Replacing the battery
A lithium button cell is located within the device, which must be only replaced by MAGNA
Telemotive GmbH.
Mechanical exposure
++++++++++++++ Operation envir+++++++++++++
Height: - 300 to 5500 m
Shock at 2 ms half sinusoidal wave
300 G
Vibration sinusoidal wave
3 G (10
– 50 Hz)
2.5 G (50
– 2000 Hz)
2 G (200
– 5000 Hz)
++++++++++++++ Out of operation envir+++++++++++++
Height: - 300 to 12000 m
Shock at 1 ms half sinusoidal wave
800 G
Vibration sinusoidal wave
up to 5 G (10 - 500 Hz)
