BLUEPIRAT MINI | USER MANUAL /
page 20 of 62
The logger is in an undefined state and will not record any data.
Only after rebooting the device behaves as expected.
The data on the SD card can then be unreadable when the SD card is removed during a
write operation.
If you turn off the BLUEPIRAT Mini with the
[ON / Trigger]
button, you have 5 seconds to re-
move the disk before the logger can be reawakened.
7.7
ETH #3 and ETH #4
The network ports at the rear side,
ETH #3
and
ETH #4
, can be used for logging data.
Warning:
Don’t connect ETH #3 and ETH #4 directly to each other.
7.8
Multifunction connector 44-pol SUB-D HD
At
BLUEPIRAT Mini
8 CAN / 4 CAN-FD / 8 LIN / 20 LIN / FlexRay this connector has these
functions, depending on the logger model:
Power supply
KL 30 and KL 31
Clamp 15
KL 15
High Speed CAN
HS-CAN
Low Speed CAN / Remote Control
LS-CAN
CAN-FD
CAN-FD
LIN
LIN
FlexRay
FR x Ch A / Ch B
Serial
RS232
Analog-Digital IN
ANA IN / ANA COM
Digital OUT
DIG OUT
Broad-R-Reach
®
BRR
The pinning is described in chapter 15
Notice:
The logger is protected against reverse polarity of the power supply. But devices which
are connected to the logger can be damaged when the logger is connected in the wrong
way.
7.9
Multifunction connector 15-pol SUB-D
At BLUEPIRAT Mini MOST this connector has these functions:
Power supply
KL 30 and KL 31
High Speed CAN
HS-CAN
Low Speed CAN / Remote Control
LS-CAN
Serial
RS232
Analog-Digital IN
ANA IN / ANA COM
Digital OUT
DIG OUT
The pinning is described in chapter 15
