BLUEPIRAT MINI | USER MANUAL /
page 22 of 62
8
Starting the BLUEPIRAT Mini
Connect the
BLUEPIRAT Mini
to the vehicle battery or a power supply via the power harness
(
red/Vbat/+/clamp 30
and
black/GND/-/clamp 31
).
Connect the Gigabit-Ethernet-port
ETH #1 / TSL
with the Ethernet port of your computer by us-
ing a Ethernet cable.
(Note: By default the BLUEPIRAT Mini is configured as *Automatic
DHCP-configuration for TSL
with IP
192.168.0.233*.)
Figure 8.1: Power connection
When the power supply is switched on, the logger will start automatically when you plug in the
power supply.
Is the BLUEPIRAT Mini in standby mode please press the
[ON / Trigger]
button to start the de-
vice.
To switch off the BLUEPIRAT Mini please press the
[ON / Trigger]
button for about 5 seconds
till the green ACTIVE-LED starts pulsing.
The boot sequence takes about 15 seconds, until the logger is reachable by the System Client.
Data logging is starting much earlier.
Figure 8.2: Switching on the BLUEPIRAT Mini
