BLUEPIRAT MINI | USER MANUAL /
page 35 of 62
11.2
LIN
The BLUEPIRAT Mini is able to record data compliant to the LIN specification V1.3, V2.0 and
V2.1. The data logger does not actively appear as a bus member. Sending LIN messages is
n’t
supported currently.
Channels
up to 20
Transmission Rate
1200, 2400, 4800, 9600, 19200, 20000 Baud
Transmitter
TJA1021
Status
Parity BITS, format Check for Header,
Checksum for Header and Payload
Terminating resistor
30 kOhm
Table 11.2: LIN
11.2.1
LIN data blocks and time stamps
Each LIN message receives a time stamp, which marks the end of the message. If the data log-
ger receives LIN data without a valid header, it creates blocks containing the erroneous data.
The maximum block size is 10 bytes. A block is also concluded after a timeout, which is three
times the transmission time of a LIN character.
11.2.2
LIN transceiver
The BLUEPIRAT Mini uses the LIN transceiver TJA1021 by NXP (former Philips Semiconduc-
tor). Supported baud rates are in the range from 1200 to 20000 Baud. Automatic baud rate de-
tection is currently not supported. The LIN interface is configured as a slave device with a
terminating resistor of 30 kΩ.
11.2.3
Special frames and states
Additionally to the normal frame data, the following information is recorded:
Wake-Up Frames
Checksum Errors
