BLUEPIRAT MINI | USER MANUAL /
page 16 of 62
7
Controls and ports
This chapter describes the usage of the controls and ports on the front and rear side of the
BLUEPIRAT Mini.
7.1
ON / Trigger button
The
[ON / Trigger]
button on the front panel is used for these actions:
Function
Device status
Handling
Start device
out of action
Push the
[ON / Trigger]
button.
Wake up device
in standby mode
Push the
[ON / Trigger]
button.
Set Marker
in operational state
Push the
[ON / Trigger]
button.
Shut down device
(to standby mode)
in operational state
Push and hold the
[ON / Trigger]
button.
(about 3 to 5 seconds)
Reset network settings
back to default settings
in standby mode
Start the device.
Push and hold the
[ON / Trigger]
button,
until the STATE-LED flashes red twice.
(~ 15 seconds)
Shut down device and start it again, to
set the settings.
Table 7.1: Overview of the functions of the [ON / Trigger] button
Note: The [ON / Trigger] button has set a debouncing time of 335 ms.
7.2
Resetting the logger to factory settings
Beside the possibility to reset the network settings, the BLUEPIRAT Mini offers the possibility to
reset the device to factory respectively delivery status, if the logger is in error state and there’s
no chance to connect to the logger any more (even after a network reset).
Warning:
Due to the reset to factory settings all data and licenses on the logger will be deleted.
Needed licenses have to be installed on the logger again after this operation.
An actual firmware version has to be flashed after this procedure. This is signaled by the
STATE-
LED and a failure message “FC_FW_UPDATE” at the client.
To reset the logger to factory settings the logger has to be unplugged from power supply.
While you connect the logger with the power supply again, press the
[ON / Trigger]
button, until
both LEDs are pulsing.
Note: If you do nothing, the logger tries to startup normally, in case of the button was
pressed by mistake during plug in.
During the short phase, in which the LEDs are pulsing (for about 10 seconds), quickly press
many times the
[ON / Trigger]
button, until both LEDs are blinking alternately.
The device starts to reset itself to factory settings. This operation will take some minutes. The
BLUEPIRAT Mini will switch off after that automatically.
7.3
LEDs
The
BLUEPIRAT Mini
has two LEDs
ACTIVE
and
STATE
on his front side. They can have the
following states.