BLUEPIRAT MINI | USER MANUAL /
page 19 of 62
7.6
SD card slot
The
BLUEPIRAT Mini
offers the possibility to store data parallel to a removable media as SD
card or USB device. The configuration of this feature is described in the System Client user
guide.
Requirements:
Size
At least 4 GB (or a partition at least with this size)
Free memory
At least 3 GB for the circular buffer (only for parallel recording)
File system
FAT32, NTFS or ext4
Write protection
unlocked
7.6.1
Recommended SD cards
The following SD cards have been tested with the BLUEPIRAT Mini and released for use:
Manufacturer
Description
Size
Type
SanDisk
Extreme PRO SDXC UHS-I Card
512 GB
SDXC
SanDisk
Extreme PRO
64 GB
SDXC
Transcend
Ultimate Speed
64 GB
SDHC
Transcend
Ultimate Speed
32 GB
SDHC
Transcend
Ultimate Speed
16 GB
SDXC
Kingston
SD10VG2
32 GB
SDHC
Kingston
SDA3
16 GB
SDHC
Intenso
3431490 Professional
64 GB
SDXC
Intenso
3431470
32 GB
SDHC
Hama
Class 10 45 Mbps
64 GB
SDXC
Hama
Class 10 45 Mbps
16 GB
SDHC
Extrememory
HyPerformance Class 10
32 GB
SDHC
Extrememory
Performance Class 6
16 GB
SDHC
SanDisk
Extreme
32 GB
SDHC
Table 7.4: Compatible SD cards
Attention:
The format of cards over 32 GB with FAT32 must be done via a Linux system, since Win-
dows only supports the formatting of FAT32 up to 32 GByte.
Removing the SD card without prior shutdown may result in the loss of all recorded data.
If the removable media is detected by the logger, the red State LED starts flashing.
A write-protected SD memory card will be indicated by the permanent illumination of the red
STATE LED.
In addition, the write protection will be highlighted in the network logger window of the System
Client with a red labelled exclamation mark and an entry in the bug report
FC_MS_READ_ONLY” with a corresponding note.
Then shut down the bP Mini, unlock the SD card, reinsert it and reboot the device.
If the SD card is pulled in the operational state, the following problems exists: