BLUEPIRAT RAPID | USER MANUAL/
page 38 of 67
Cable sets
When inserting the cable sets in the usual case, only a slight force is required. At an increased
mechanical resistance during insertion of the cable set, the correct alignment of the pins should
be checked.
Special cable sets are to be manufactured strictly according to the sheet of the instruction man-
ual containing the pin assignment, whereby an extra fuse provided on the cable set must be
considered. The connectors specified in the instruction manual should be used.
Two pairs of pins are assigned to only one type of electrical potential, that means an intercon-
nection to positive electrical potential (Klemme 30/Clamp 30) for one related pair and the nega-
tive one (Klemme 31/Clamp 31) for the other matching pair.
Network cables for connection to the data logger must be at least category 6A (STP or even
S/FTP). The use of unshielded cables is not permitted.
The cable sets’ temperature range is restricted to -20°C to +70°C due to the banana plugs.
Mounting
In laboratory setups and automobiles the units must be attached in such a way, that it is en-
sured against dropping, slipping and skidding.
Positioning of the antenna
The data loggers themselves are not provided with wireless communication facilities to other de-
vices or technical equipment.
External modules are available for this functionality, which can be connected to the data logger
via the two USB3.0 ports.
Any external antennas of these modules must not be located outside the vehicle!
Replacing the battery
A lithium button cell is located within the device, which must be only replaced by MAGNA
Telemotive GmbH.
Mechanical exposure
++++++++++++++++++ Environment during ope++++++++++++++++
Height: -300 to 5500 m
++++++++++++++++++ Environment out of s++++++++++++++++++
Height -300 to 12000 m
