BLUEPIRAT RAPID | USER MANUAL/
page 16 of 67
6.4
State LEDs
The BLUEPIRAT Rapid has 4 state LED at the front side
Figure 6.5: BLUEPIRAT Rapid
– state LEDs
6.4.1 State LED (
red
)
Table 6.1: state LED
6.4.2 Active LED (
green
)
Table 6.2: active LED
The mentioned states of the
Active-LED
are additionally overlaid by a fast flashing if data traffic
takes place on one of the activated interfaces (with the exception of protocol-based Ethernet
logging).
If a trigger is initiated (external or internal), the ACTIVE LED lights up briefly with full brightness.
6.4.3 First Frame mode LED (
blue
)
Table 6.3: active LED
State
Meaning
off
No error, normal operational status
on
Device is in error state.
If the device is still reachable by the client, the error and some hints to solve this
issue can be found in the bug reporter.
blinking
Overload of the data logger; maybe loss of data
Information about lost data can be found in the bug reporter..
blinking
tbd
State
Meaning
off
Device is off or in standby mode.
on
Device has started up and can be reached by the client.
blinking
Device is starting up.
pulsing
Device goes to standby mode.
State
Meaning
off
tbd
on
First Frame data are send to the normal data storage
blinking
tbd
pulsing
tbd
