BLUEPIRAT RAPID | USER MANUAL/
page 22 of 67
9
Starting the BLUEPIRAT Rapid
9.1
Hook up the BLUEPIRAT Rapid
Connect the wiring harness to one of the two available sockets for the power supply on the
BLUEPIRAT Rapid. Then connect power and ground (red/Vbat/+/clamp30 and black/GND/-
/clamp31). to the vehicle battery or a power supply.
Figure 9.1: BLUEPIRAT Rapid
– connecting the power supply
Connect one of the two 10 GBit-Ethernet / TSL ports with the Ethernet port of your computer by
using a Ethernet cable.
Note: By default, the device is configured as Automatic DHCP configuration for with default IP
address 192.168.0.233!
Figure 9.2: BLUEPIRAT Rapid
– connection to your computer
9.1.1 Power on/off the BLUEPIRAT Rapid
Step 3: Switch on the BLUEPIRAT Rapid by pressing the [ON / Trigger] button and wait until the
logger is ready and the green LED is still on.
Figure 9.3: Power on/off the BLUEPIRAT Rapid
To switch off the BLUEPIRAT Rapid later, please press the [ON / Trigger] button for a few sec-
onds, until the green LED starts pulsing.
