BLUEPIRAT RAPID | USER MANUAL/
page 25 of 67
9.4
Default network settings
Important:
The loggers default setting is *Automatic
DHCP-configuration for TSL
with IP
192.168.0.233*)
and has to be connected by an Ethernet cable from „ETH #1 / TSL“ or
„ETH #2 / TSL” to your computer system.
9.4.1 Resetting the network settings
If you no longer have access to the logger, a
reset of the network settings
can solve the prob-
lem by pressing the
[On / Trigger]
key directly after switching on, during booting for approx. 10
seconds until the red State LED flashes 2 times.
The Rapid then boots completely and then reboots automatically to activate the default network
settings. (Automatic DHC configuration with IP 192.168.0.233)
9.5
Terminal IP address
Each
BLUEPIRAT
has an additional, permanently set network address internally, which can be
used to reach the device if the set IP address cannot be reached. This address can also be
used if several devices have the same IP setting. For this feature every data logger has a sec-
ond, fixed IP address in the subnet 10.1.X.Y which can be contacted by the System Client.
Each terminal IP address is unique!
These additional IP addresses are all located in subnet 10.1.X.Y. The system client can access
the devices via this IP address
Attention:
To use this option your computers network port has to be set to the fixed IP address
10.1.255.254 and subnet mask 255.255.0.0.
To set this IP address, please go to the specific network connection at
[Properties]
change the
IP settings and close the window with
[OK]
.
