BLUEPIRAT SERIES | CAMERA USER GUIDE/
page 49 of 93
8.3.2 IP configuration
Change to the entry
[Basic Configuration]
[2. TCP/IP]
. Choose the <IPv4 Address Configu-
ration>
(o) Use the following IP address
. Type in these data:
IP address:
192.168.1.90
Subnet mask:
255.255.255.0
Default router:
192.168.1.1
Figure 8.7: Setting an IP address
Note:
When using a port on the rear side of the logger, please type in the <IP address>
192.168.0.90 and the <Default router> 192.168.0.1.
The same IP address has to be used in the data loggers configuration.
Confirm the settings with
[Save]
.
Note:
By changing the IP address you lose the connection to the network camera.
This also will be told to you in an information window:
Figure 8.8: Hint 1