BLUEPIRAT SERIES | CAMERA USER GUIDE/
page 74 of 93
12
Resetting the Video Encoder AXIS Q7404 / P7214
If something is configured incorrectly in the camera or the password is lost, it is important to re-
set the video server for a new configuration. This will reset all parameters in all four video chan-
nels (including all IP addresses) to the factory default settings.
First disconnect the power supply from the AXIS Video Encoder. Then press and hold the
[RE-
SET]
button
(1)
while reconnecting with the power supply.
AXIS Q7404
Figure 12.1: Reset button AXIS Q7404
AXIS P7214
Figure 12.2: Reset button AXIS P7214
Keep the
[RESET]
button
(1)
pressed.
The STATUS LED turns yellow. This may take up to 15 seconds.
Release the
[RESET]
button
(1)
when the STATUS LED lights permanently green. This may
take up to one minute.
The video server is set back to factory default settings and can be configured again.
