Magnadyne LINEAR SERIES RV4000, Operation And Installation Manual

17

The LCD display may fail to function normally 
due to the vehicle’s battery condition, and could 
require resetting the radio microprocessor if:

• The vehicle has been “jump started” from a 

dead battery condition.

• The vehicle battery becomes very low and is 

quick-charged.

• The vehicle battery is removed and replaced.

Should any of these conditions occur, simply 

press and release the RESET button on the radio 

front panel using the tip of a ball point pen. This 

will reset the radio microprocessor to the origi-

nal factory settings. After pressing the RESET 

button you should recheck to see if the radio 

functions normally. 

 Reset Button

 Additional Feature

EQ

1

AS/PS

2

SLP

3

ALM

4

DISP

5

DIM

6

PUSH

RESET

AV HEADPHONES

A

B

AUX

AM/FM

DISC

SPEAKER

Reset Button

Area Radio Frequency Adjustment:

Note: If operating the unit in the USA do not 

change the area.

 
To Change the Area:
1.  Press the AM/FM button and “rAdIO” appears 

in the display.

2.  Press and hold the VOL/TONE knob until 

“SEtUP” appears in the display.

3.  Press the 

�

ll button and “US” or “OCEAn” 

will be displayed.

4.  Press the l

�� 

or 

��

l button to change the 

setting to “US” or “OCEAn”.

5.  Press the 

�

ll button to save the setting. The 

unit will clear all the station settings. After wait-

ing a few seconds the unit exit programming.

EQ

1

AS/PS

2

SLP

3

ALM

4

DISP

5

DIM

6

PUSH

RESET

AV HEADPHONES

A

B

AUX

AM/FM

DISC

SPEAKER