Step 4: Optional Accessory Connections
(Continued)
Starter Disable and Engine Disable Using Optional ALA-RPS2 Relay Pack:
Using the wiring information to connect the optional starter disable relay as follows:
A. Locate the “Start Only” wire coming from the ignition key switch and cut it.
B. Connect the ends of the cut start wire the black wires coming from the ALA-RPS2 relay pack.
C. Locate the power supply wire to any of the fuel management circuits listed below and cut it.
D. Connect the ends of the cut wire the white wires coming from the ALA-RPS2 relay pack.
E. Plug in the orange 2-pin plug into the orange socket located at the rear of alarm module.
To test the dual circuit disable system, refer to the starter disable testing procedures located in the
testing section of this manual.
8
Starter Disable Wiring Using Optional ALA-RPS Relay Pack:
Using the wiring information and diagram below, connect the optional starter disable relay as
follows:
A. Locate the “Start Only Wire” coming from the ignition key switch and cut it.
B. Connect the ends of the cut start wire the black wires coming from the ALA-RPS relay pack.
C. Plug in the orange 2-pin plug into the orange socket located at the rear of alarm module.
To test the starter disable system refer to the starter disable testing procedures located in the
testing section of this manual.
87
87a
86
85
30
"ACC"
"START"
"OFF"
"ON"
Cut
Starter
ALA-RPS
Relay Pack
Starter Disable Connection
Red Wire
(Ign. Sw12VDC)
Black Wire
(Ground when Armed Alarm Output)
