2
The information enclosed will provide a ready reference of the operation and maintenance of your new
remote mobile security system.
1. Exit the vehicle and close all entrances.
2. Press and release the ARM/DIS or LOCK button on the transmitter. The security system will respond as
follows:
A. The horn/siren will chirp one time.
B. The LED indicator will begin to flash at a steady rate.
C. The parking lights will flash one time.
D. All protected entrances are armed.
Note: If the dome light is on or a sensor is active at the time you arm your security system, You will
hear the horn/siren beep one time and then you will hear another beep from the horn/siren about 5
seconds later. This second beep is the active sensor warning indicator. This second beep tells you that
the alarm is armed but one of the sensors has been temporarily deleted because it was on at the time
the alarm was armed.
The security system is now fully armed!
Your security system can operate from any one of the four transmitters shown here. Locate the transmitter
that was supplied with your system and use the drawing as a ready reference while reading through the
operating procedures.
R
Silent Arming
ARM/DIS
Button
A
AUX CH#2
Button
Silent Arming
ARM/DIS
Button
AUX CH#2
Button
Silent Arming
AUX CH#2
Button
ARM/DIS
Button
B
D
PANIC
AUX
LOCK
UNLOCK
Silent Arming
LOCK/ ARM
Button
AUX CH#2
Button
UNLOCK/
DISARM
Button
PANIC
Button
C
Security System Operation:
(Using the transmitter to arm the security system)
Remote Control Transmitters
