Magnani MI-HA-IHWD02-CB, User Manual

9

10

8

11

5

Thermostat

The device features a built-in thermostat that automatically shuts 

OFF the device in case of overheating or abnormal operation. If the 

device becomes too hot (overheating), the thermostat and fuse will 
activate and stop the device from working. Allow it to cool down for 
approximately 15 minutes and the fuse will reset automatically. The 
device can be used again.
In case the device does not operate normally after it has cooled 
down, it is recommended to disconnect the device from the mains 
power and to reset the thermostat fuse manually by pressing the 
reset button key 

10

 in the small reset 

9

 buttonhole until you hear a 

click. Please use the reset butt on key 

10

 for this action. 

After resetting the thermostat, connect the device again to the 
mains power and follow the steps described at section “Using the 
device”.

After resetting the device, the thermostat has been reset, the 
boiling point needs to be set to recover normal heating function. 

Set the temperature at 100 and volume at 000 (continuous flow), 

and allow it to dispense for ± 1 minute.

Drainage stopper

In case the device will not be used for a long period of time, clean it 
and remove the remaining water.
Open the drainage stopper on key 

11

 at the bottom of the base by 

turning it counter-clockwise, so the remaining water can flow out of 

the device. Once all the remaining water has been removed, place 
the drainage stopper on key 

11

 back by turning it clockwise and 

make sure it is properly tightened.

Note!

 In case of any water leakage after filling the water tank, 

check that the drainage stopper is properly tightened.

Drip tray

The device is equipped with a removable drip tray 

5

.

When the drip trap is mounted, the available space between the 
drip tray and spout = ± 17 cm.
When the drip tray 

5

 is full, hold the device at the top, and remove 

the drip tray by moving it upwards, releasing it from the drip tray 
holders.
Empty the drip tray 

5

, rinse it with running water, dry it with a dry 

cloth and place it back by sliding it over the drip tray holders 

5

with a gentle push.

EN 06

4) CLEANING - MAINTENANCE & DESCALING

4) CLEANING - MAINTENANCE & DESCALING

 Descaling

To maintain its performance, it is recommended to descale the device on a monthly basis in case of regular use.

Only use a toxic free detergent such as citric acid or vinegar!

Pour some citric acid or vinegar into the water tank (above the MIN mark), preferably 2 litres, and operate it 

with the temperature set at 100 °C and volume set at 000 (continuous flow). Dispense the liquid until the tank is 

empty.