11
SPeCIFICATIONS
Frequency response:
5 Hz – 20 kHz (+/- 0.5 dB)
Signal to noise ratio :
109 dB (20 Hz – 20 kHz, A-weighted)
channel separation:
> 106 dB (1 kHz)
Output voltage:
2.0 V (10 kOhm)
Harmonic distortion:
< 0.0012%
Digital outputs:
1 x optical (Toslink™)
1 x coaxial (RcA)
Digital inputs:
1 x USB 2.0 type B port
1 x optical (Toslink™)
1 x coaxial (RcA)
Supported sampling frequencies: 44.1/48/88.2/96/176.4/192kHz
Supported Bit depths:
16/24Bit
Upsampling:
Switchable upsampling function to 192 kHz/24 bit
for cDs and digital inputs
Mains voltage:
230 VAc / 50 Hz
Electricity consumption:
Type
25 W
Standby
0,5 W
Fitted with:
2 x Ecc 88
Playable formats:
cD-DA, HDcD, cD-R, cD-RW
Dimensions (wxhxd):
Main device:
434 x 90 x 330 mm
Main device incl. operational
elements/connecting terminals:
434 x 90 x 345 mm
Remote control:
47 x 198 x 23 mm
Weight:
7.5 kg
For further information please visit our website: http://www.magnat.de.
INITIAl OPeRATION
• Place the McD 1050 on an even surface. Observe the relevant clearance gaps as specified under
“Important safety instructions“.
IMPORTANT
: Do not place any objects on top of the device (magazines, cD/record cases, etc.).
The ventilation slots located on top of the device must be unobstructed at all times!
• connect an audio output (analogue or digital) to a suitable amplifier. Also refer to the operating
instructions for the device when doing this.
• connect the supplied mains cable to the rear and then insert the other end into a 230V socket.
• Actuate the on/off switch on the rear side, the device is now in the standby mode.
• Switch on the device using the ON/STANDBY button on the front panel or the remote control.
• When the tubes have heated up the device is ready for use.
TUBe RePlACeMeNT
The device has a high quality preamplifier stage which is equipped with two tubes. The tubes have a
very long service life when used under normal operating conditions (min. 20,000-50,000 hours).
If it is necessary to replace the tubes, please refer to a specialist dealer.
SeRVICe AND TeCHNICAl PROBleMS
If you should encounter any technical problems, please contact your specialist dealer or
Magnat Audio-Produkte GmbH, Tel.: 02234807-0.
If a digital signal is not available at the selected
input, the message „NO SIGNAL“ will appear
in the display:
27 eject
Opens the cD compartment.
28 Stop - Play/Pause
Right button: Starts or pauses the playback
from a cD.
Left button: Stops a cD that is playing.
29 Search
High-speed rewind and fast forward. Remains
active as long as the button is depressed.
30 Skip
Playback starts at the beginning of the current
or next track.
Pressing the left button twice starts playback at
the beginning of the previous track.
31 Headphone
Increases (+) or reduces (-) the volume of the
headphone jack between -64dB and 0dB in
1dB steps.
The non-numbered buttons are reserved for
operating the Magnat amplifier MA 1000 and
have no function for the McD 1050.
Subject
to
technical
change.
