Cable Box Connections
2
TO
TV/VCR
CABLE
IN
IR
USB
DVD-D OUT
AUDIO IN
SPDIF
VIDEO
IN OUT
S-VIDEO
R L
AUDIO OUT
TV
PASSCARD
Y Pb Pr
OPTICAL
SPDIF
1
2
75
Ω
75
Ω
3
Jack Panel Back of Cable Box
Cable Signal IN
from the Cable
Company
Round 75
Ω
Coaxial Cable
Jack Panel Back of TV
I
f you cable signal uses a cable box or
decoder, follow the easy steps below to
complete the connection.
Cable Box (w/RF In/Outputs):
This connection will be mono.
1
Connect the Cable Company
supplied cable
to the signal
IN(put) plug on the back of the
Cable Box.
2
Using a separate round coaxial
cable,
connect one end to the
OUT(put)
(TO TV) plug on
the back of the Cable Box.
3
Connect the other end of the
round coaxial cable
to the 75
Ω
input on the back of the television.
Screw it down finger tight.
NOTE:
If applicable, set the OUTPUT
CHANNEL SWITCH on the back of the
cable box to CH 3 or 4. Tune the TV to
the same channel and change channels
at the cable box. In some cases, the
cable box will automatically tune to
either channel 3 or 4, change channels
until the picture appears.
If no Video Signal is present, the TV
will shut itself off in about 10 minutes.
If the TV is tuned to the AV channel
and there is no Video Signal present,
the screen will remain black and the
TV will shut itself off in about 10 min-
utes.
Helpful Hints
Summary of Contents for 13MT143S, 20MT133S, 20MS233S
Page 34: ...NOTES 30...
Page 35: ...NOTES 31...