Connecting the Antenna, Cable or Satellite
Be sure your Antenna or another Device is connected properly before
plugging in the AC Power Cord.
If connecting to an Antenna through an RF cable
Any DTV Programs that are Broadcast in your area can be received for
free through an Antenna Connection.
RF cable
RF cable
RF cable
OUT
IN
IN
IN
Cable
Antenna
If you connect a Set-top Box through an RF cable
If the TV is connected to a Cable or Set-top Box via a Coaxial Connection,
set the TV to channel 3/4 or the channel specified by the service provider.
IN
IN
IN
Set-top Box
RF cable
RF cable
RF cable
RF cable
IN
IN
IN
Antenna
Antenna
Antenna
OUT
If connecting a Set-top Box through an HDMI cable
If the TV is connected to a Set-top Box via an HDMI cable, make sure
you select the correct Source by using
SOURCE
button on TV or Remote
Control.
Set-top Box
IN
RF cable
HDMI cable
HDMI cable
HDMI cable
IN
IN
IN
OUT
If connecting a Set-top Box through Component Video Input
If the TV is connected to a Cable or Set-top Box via Component Video
Input, make sure you select the correct Component Video Source by
using
SOURCE
.
IN
IN
IN
IN
IN
IN
OUT
OUT
Component (Y/Pb/Pr)
Video cables
Component (Y/Pb/Pr)
Video cables
Component (Y/Pb/Pr)
Video cables
Audio (L/R) cables
Audio (L/R) cables
Audio (L/R) cables
Set-top Box
IN
RF cable
Connecting a Set-top Box, Blu-ray Disc / DVD Recorder
via Composite Connectors and Analog Audio
Do Not place your Recorder too close to the Screen because some
Recorders can be susceptible to Signals from the TV.
RF cable
RF cable
OUT
OUT
OUT
Audio (L/R) + Video
cables
IN
IN
IN
Cable
RF cable
RF cable
RF cable
RF cable
Audio (L/R) + Video
Audio (L/R) + Video
cables
cables
RF cable
RF cable
IN
IN
OUT
OUT
IN
IN
IN
Set-top Box
OUT
OUT
OUT
OUT
Audio (L/R) + Video
cables
Audio (L/R) +
Video cables
IN
IN
IN
Blu-ray Disc /
DVD Recorder
Note(s)
●
If you have any question about the DTV’s Antenna, visit
www.antennaweb.org
for further
information.
●
Depending on your Antenna system, you may need different types of combiners (mixers)
or separators (splitters) for HDTV Signal. The minimum RF bandpass on these Devices is
2,000MHz or 2GHz.
●
For your safety and to avoid damage to this Unit, please unplug the RF Coaxial Cable from
the Antenna Input jack before moving the Unit.
●
If you did use an Antenna to receive Analog TV, it should also work for DTV reception.
Outdoor or attic Antennas will be more effective than a Set-top Box or inside Antenna.
●
To Turn On your reception source easily between Antenna and Cable, Install an Antenna
selector.
●
If you are not receiving a Signal from your Cable service, contact the Cable provider.
●
Refer to the Quick Start Guide that shows the connections for the HDMI or Component
Input mode.
Plugging in the AC Power Cord
Make sure All the Necessary Connections are made before the AC Power
Cord is plugged into an AC outlet.
Caution(s)
●
Do Not connect the AC Power Cord to an AC Power Supply outside the indicated voltage
of this Unit (120V AC).
●
Connecting the AC Power Cord to a Power Supply outside of this range may result in
Unit failure, degradation or electrical shock.
Note(s)
●
Each time you plug in the AC Power Cord, no operations will be performed for several
seconds. This is not a malfunction.
11
.
English
Continued on next page.
