12
WATCHING TV
Sleep Timer
can set the unit to go into standby mode after an incremental period of time.
p
Press
SLEEP
repeatedly to change the amount of time (increases
the time by 30 minutes up to 120 minutes).
Sleep 120min.
Press
SLEEP
once to call up the display for checking the remaining time.
• To cancel sleep timer, press
SLEEP
repeatedly until
[Sleep Off]
is
displayed.
Switching Each Input Mode
can easily switch with the remote control
between TV (ATSC or NTSC) and external devices when they are connected to the unit.
Press
SOURCE
or
CH +
repeatedly to cycle through the input modes.
Source
TV
HDMI1
HDMI2
HDMI3
Component
Video
e.g.)
11.1
HDMI1
HDMI2
DTV / TV channel
(or PC Input)
Video
Component
HDMI3
• Pressing
CH
−
reverses the direction of the input modes.
Freeze Mode
can freeze the image shown on the TV screen for 5 minutes.
Press
FREEZE
to freeze the image.
Freeze
• The sound output will not be paused.
• To cancel freeze mode, press any buttons except .
Channel Selection
Select channels by using
CH +/
−
or
the Number buttons
.
• To select the memorized channels,
use
CH +/
−
or
the Number buttons.
• To select the non-memorized channels,
use
the Number buttons.
11.1
To use
the Number buttons
ATSC
-
When selecting digital channel 11.1
Be sure to press • before entering the subchannel number.
NTSC
-
When selecting cable or analog channel 11
Press
PREV CH
to return to the previously viewed channel.
Note
•
[No Signal]
will appear on the TV screen after the subchannel
broadcast is over.
•
[Audio only program]
message will appear on the TV screen, when you
receive only sound signal.