17
English
4 Use your TV
Switching on your TV and putting it in
Standby mode
To Turn the TV On from Standby or Off to Standby
•
Press (3 raised dots on the Rear panel) or Front panel or the
Remote control.
Adjusting volume
To decrease or increase volume
•
Press
VOL
◄
/
►
(1 raised dot on the Rear panel) or Front panel
or press
VOL + /
−
on the Remote control.
VOL
◄
: Volume Down
VOL
►
: Volume Up
To mute or unmute sound
•
Press on the remote control to mute the sound.
•
Press again or
VOL + /
−
to recover the original sound.
Switching channels
To select Channels by using CH
▼
/
▲
or CH + /
−
•
Press
CH
▼
(Down) /
▲
(Up - 1 raised dot on the Rear panel) or
Front panel or press
CH + /
−
on the Remote control.
To select Channels by using the NUMBER buttons
•
For Digital channels, press a number followed by a dot “•” and the
corresponding sub channel number.
–
When selecting Digital channel 11.1
Be sure to press • before entering the subchannel number.
–
When selecting cable or Analog channel 11
Press
PREV.CH
to return to the previously viewed channel.
* On the 46” & 50” TV’s All CONTROL Keys are located on the Rear
(lower right) side of the unit as viewed from the Front.
Note
• Energy consumption contributes to air and water pollution. When the AC power cord
is plugged in, your TV consumes energy. Your TV has very low standby power
consumption.
50ME313V / 46ME313V
39ME313V / 39ME413V / 32ME303V /
32ME403V / 29ME403V / 24ME403V
* Key on Rear
50” - 39”
32” - 24”
50ME313V / 46ME313V
39ME313V / 39ME413V / 32ME303V /
32ME403V / 29ME403V / 24ME403V
* Keys on Rear
Note
• To select the non-memorized channels, use
the NUMBER buttons
.
•
No Signal
will appear on the TV screen after the subchannel broadcast is over.
•
Audio only program
message will appear on the TV screen, when you receive only
sound signal.
50” - 39”
32” - 24”
50ME313V / 46ME313V
39ME313V / 39ME413V / 32ME303V /
32ME403V / 29ME403V / 24ME403V
* Keys on Rear
Digital TV operation
Analog/Cable TV operation
