TV-KIT-010 Instructions Magnavox HVG Repair - 7621
Last Updated Monday, 29 October 2012 14:51
6. Place the pump over a piece of paper and press the pump bulb to blow out the solder
onto the paper.
7. Repeat the steps above
Using the desoldering iron shown above slowly remove the solder from the High Voltage
Generator pins on the underside of the board as shown in the photo below.
After you have removed the solder you will need to straighten the metal clamps to remove the
HVG. You may also have to use your soldering iron to melt any solder that may have been used
to weld the clamps to the board.
12 / 17
