3 Use your TV
Switching on your TV and putting it in
standby mode
Remote control
TV
To turn the TV on from standby or off to standby
●
Press
B
on the TV or the remote control.
Note(s)
●
Energy consumption contributes to air and water pollution. When the AC power
cord is plugged in, your TV consumes energy with a very low standby power
consumption.
Adjusting volume
Remote control
TV
To decrease or increase volume
●
Press
VOL + / –
on the TV or the remote control.
VOL
+ : Volume up
VOL
– : Volume down
To mute or unmute sound
●
Press
D
on the remote control to mute the sound.
●
Press
D
again or
VOL + / –
to recover the original sound.
Switching channels
TV
Remote control
To select channels by using CH + / –
●
Press
CH + / –
on the TV or the remote control.
To select channels by using the NUMBER buttons
Digital TV operation
●
For digital channels, press a number followed by a dot “
•
” and
the corresponding sub channel number.
–
When selecting digital channel 11.1
Be sure to press
•
before entering the subchannel number.
Cable / NTSC (Analog) TV operation
–
When selecting cable or analog channel 11
Press
PREV.CH
to return to the previously viewed channel.
Note(s)
●
To select the non-memorized channels, use
the NUMBER buttons
.
●
Channel not available
or
No signal
will appear on the TV screen after the
subchannel broadcast is over.
●
Audio only
message will appear on the TV screen, when you receive only sound
signal.
19
.
English
Continued on next page.