5 Useful tips
FAQ
Question
Answer
My remote control does not
work.
What should I do?
●
Check the antenna or cable connection to the main unit.
●
Check the batteries on the remote control.
●
Check if there is an obstacle between the infrared sensor window and the remote control.
●
Test the IR signal output use
IR signal check
.
If okay, then possible infrared sensor trouble.
●
Aim the remote control directly at the infrared sensor window on the front of the unit.
●
Reduce the distance to the unit.
●
Re-insert or replace the AAA batteries with their polarities (+/–) as indicated on the remote control battery
area.
●
When there is an infrared-equipped device such as PC near this unit, it may interrupt the remote control signal
on this unit. Move the infrared-equipped device away from this unit, change the angle of the device's infrared
sensor or turn off the infrared communication function.
How come the initial setup
appears every time I turn
on this unit?
●
Make sure to complete the initial setup before the unit goes into standby mode.
Why can I not watch some
RF signal TV programs?
●
Autoprogram must be completed when you set up the unit for the first time or move it to a location where
previously unavailable channels are broadcast.
●
Make sure auto programming has been completed.
●
The selected channel may not be broadcasting.
●
When Auto programming is interrupted and not completed, some channels will not be received. Make sure
to complete the Autoprogram.
●
The selected channel cannot be viewed by the
Child lock
●
The unit requires some kind of antenna input. An indoor antenna (Digital or VHF / UHF), an external antenna
(Digital or VHF / UHF) or an RF coaxial cable from your wall cable or set-top box needs to be plugged into the
unit.
How come there is no
image from the connected
external devices?
●
Check if the correct input mode is selected by pressing
SOURCE
●
Check the antenna, cable or other input connection to the unit.
●
When using the component video connection check that the green (Y), blue (Pb/Cb) and red (Pr/Cr) connectors
are connected to their corresponding colored jacks on the unit.
When I enter a channel
number, why does it
change automatically?
●
Many digital channels have alternate channel numbers. The unit changes the numbers automatically to the
ones signifying the broadcasting station's channel number. These basic numbers used for the previous analog
broadcasts. (e.g., input digital ch# 30 automatically changes to digital ch# 8.1)
Why are captions not
displayed entirely?
Or why are captions
delayed behind the dialog?
●
Closed captions that are delayed a few seconds behind the actual dialog are common for live broadcasts.
Most captioning production companies can display a dialog to maximum of 220 words per minute. If a dialog
exceeds that rate, selective editing is used to insure that the closed captions remain up-to date with the
current TV screen dialog.
How can I set the clock?
●
There is no clock function on this unit.
My PIN code no longer
works, how can I change
the child lock setting?
●
Although the default PIN code (0000) is supplied with the unit, the PIN code will be required once you set a
PIN code in
Child lock
.
When you forget your PIN code, enter 0711 in
Change PIN
When I start up the TV or a
net service, a message
appears on the screen
prompting for software
update again.
●
When you start up the TV or a net service after executing the software update, a message may appear on the screen prompting
for software update again. In this case, please select
Update
to start USB update or network update.
51
.
English
Continued on next page.
