29
EN
EN
Connections
Basic Setup
Recording
Playback
Editing
Introduction
Function Setup
Others
Español
Connections
B
as
ic Setu
p
Basic Setup
Recording
Playback
Editing
Introduction
Function Setup
Others
Español
CHANNEL SETTING
Auto Channel Scan
If you have changed antenna connection, we recommend that you program available channels in your area with the
following procedures.
1
Press [MENU] and use [
K
/
L
] to select
“General Setting”, then press [OK].
“General Setting” menu will appear.
2
Use [
K
/
L
] to select “Channel”, then
press [OK].
“Channel” menu will appear.
3
Use [
K
/
L
] to select “Auto Channel
Preset”, then press [OK].
4
Use [
K
/
L
] to select the type of
broadcasting signal, then press [OK].
Auto Channel Preset
Antenna
Cable (Analog)
Cable (Analog / Digital)
The unit will start getting channels available in
your area.
• When using Antenna, Cable Box or Satellite
Receiver with the RF Coaxial cable, you would
scan with the “Antenna”.
• When connected to Cable TV, select “Cable
(Analog)” or “Cable (Analog / Digital)”.
To cancel the auto channel preset during
scanning:
Press
[RETURN]
to go the previous screen or
[MENU]
to cancel.
5
When scanning is over, press [MENU]
to exit.
To cycle through only the memorized channels, use
[CHANNEL
/
]
.
To select a channel directly (including the ones not
memorized), use
[the Number buttons]
and
[ • ]
(for
digital TV channels).
Note(s)
• If Auto Scan is cancelled during the scanning, some
channels will not be programmed.
Summary of Contents for MDR557H
Page 126: ...126 ES MEMO...
