59
EN
EN
Recording
Basic Setup
Connections
Playback
Editing
Introduction
Function Setup
Others
Español
Note(s) for DV Dubbing
• If you press
[PAUSE
F
]
at step 5, the Memory card will go in reverse to a point a few seconds preceding the
paused point.
When you press
[OK]
at step 6, then, it will start Dubbing when it comes to the paused point.
• The unit does not send out the output signal to DVC.
• For the proper operation, connect DVC to the unit directly. Do not connect this unit and DVC via any other unit.
• Do not connect more than 1 DVC.
• The unit can only accept DVC. Other DV device such as cable/satellite box or D-VHS VCR cannot be recognized.
• If no video signal is detected from the DVC during DVC to HDD or DVD Dubbing, the recording will be paused and
“
I
” will flash on the TV screen. The recording will resume when the unit detects the video signal again.
• When the DVC is in camera mode, refer to “Guide to DV and On-Screen Display” on page 57.
• Date / time and cassette memory data will not be recorded.
• Pictures with a copy-guard signal cannot be recorded.
• A DV terminal is a terminal that can use the transmission mode conforming to the IEEE 1394 standards called “Fire
Wire”. It serves as the interface that connects the PC and peripheral device such as “i.LINK” (registered trademark
of SONY). It enables digital Dubbing between DV devices with little degradation.
• You cannot dub from DVC to both HDD and DVD at the same time.
• Please contact the DVC manufacturer if you have any problem with it.
DUBBING
6
Use [
K
/
L
] to select “Start Rec”, then
press [OK].
The Dubbing will start.
7
To stop Dubbing;
A) Press [
C
STOP] on the unit. or
B) Use [
K
/
L
] to select “Control”,
then press [OK].
Use [
K
/
L
] to select “HDD” /
“DVD”, then press [OK].
Then press [STOP
C
].
Summary of Contents for MDR557H
Page 126: ...126 ES MEMO...
