EN - 16
Connecting to a TV Using an HDMI Cable
• HDMI outputs the Digital Video / Audio signals without converting to them to Analog signals.
• No Audio connection is required as Digital Audio is sent through the HDMI cable.
• High speed HDMI Cable (also known as HDMI category 2 Cable) is recommended for better compatibility.
• Use an HDMI Cable with the HDMI logo (a certified HDMI Cable) for this Connection.
• Refer to ‘HDMI Video Resolution’ on page 55 for setting the HDMI Video Resolution.
R AUDIO
R AUDIO
ANTENNA
IN
OUT
L
VID
DEO
O
O
OP
PTI
CA
A
AL
RE
ES
SET
T
5
5
5V
V
V
9
900
0m
mA
A
H
H
HD
D
DM
MI OUT
D
U
U
US
SB
B
U
LAN
D
DIG
GIT
TA
AL O
OUT
L
VID
DEO
O
ANTENNA
IN
OUT
HDMI OUT
HDMI OUT
ANTENNA
IN
OUT
HDMI IN
ANT. IN
or
HDMI Cable
(not supplied)
RF Coaxial
Cable
Digital Cable TV
Do not Tilt the Connector when inserting it into the HDMI jack
and make sure the Shape's of the Jack and the Connector are
matched before Inserting the HDMI cable. Make sure the HDMI
cable is completely inserted.
Rear of thiss unit
[
MDR868//867H
below
w/LAN coonnector]
DTV
(VHF / UHF)
Antenna
RF Coaxial Cable
(supplied)
This Connection is for
TV pass through only
■
Supplied Cables used in this Connection are as follows:
• RF Coaxial Cable x 1
Please purchase the rest of the necessary Cables at your local store.
Note(s)
• Some devices with an HDMI input may not operate properly with this unit.
• When using an HDCP-incompatible Display device, the image will not be viewed properly.
• The Audio signals (including the sampling frequency, the number of Channels and bit length) from the HDMI connector
may be limited by the device that is connected.
• When this unit’s HDMI connector is connected to a DVI-D compatible Monitor (HDCP compatible) with an HDMI-DVI
converter Cable, the signals are output in Digital RGB.
• When a Power failure occurs or when you unplug the unit, some problems with the HDMI setting might occur. Please
check and set the HDMI setting again.
EN.indd 16
2015/09/02 19:00:31
