EN - 58
Subtitle Recording
Record to DVD with Closed Caption or not.
1
Select a desired item using
[
K
/
L
]
, then
press
[ OK ]
.
Old
Off
Record to DVD with Closed Caption.
Record to DVD without Closed
Caption.
• Your setting will be activated.
Others
1
Select a desired item using
[
K
/
L
]
, then
press
[ OK ]
.
2
Set the Selected item in references below.
Initial Setting
Setting up the unit again. Refer to ‘3.
INITIAL SETUP’ on page
22.
• Make sure that the Antenna Connection was completed.
Standby Settings
This unit boots up at a higher speed in “Normal Standby”.
activation, but Power Consumption in Standby mode will be
increased.
1
Select a desired item using
[
K
/
L
]
, then
press
[ OK ]
.
Normal Standby
In order to make the unit Start faster, then set to “Normal
Standby”, if done then this will increase the Power
Consumption when the Power is Off in Standby mode.
Energy Saving Standby
"Energy Saving Standby" will reduce the Power
Consumption during Standby rather than “Normal
Standby”.
• Your setting will be activated.
Note(s)
• If you Select “Energy Saving Standby”, “fun-link(HDMI CEC)”
is automatically set to “Off ” and “Network Function” will be
set automatically to “Do Not Use”.
Remote Control
Code Select
Code Select
Sets the remote conntrol Code 1/2/3 for your Remote Control.
By setting the Remote Control Code to this unit, you can
prevent other devices from responding when you use the
Remote Control.
1
Select your preferred Remote Control
Code using
[
K
/
L
]
.
2
Keep pressing
[ OK ]
, then press the
Remote Control Code you Selected.
Code Select
Code1
Code2
Code3
Sets the Remote Control Code to 1.
Sets the Remote Control Code to 2.
Sets the Remote Control Code to 3.
Code Alert
Code Alert
Set whether you want to Display a message when the unit is
receiving a different Remote Control Code.
1
Select a desired item using
[
K
/
L
]
, then
press
[ OK ]
.
Code Alert
Old
Off
If this unit receives a different Remote
Control Code, an error message will
appear.
If this unit receives a different Remote
Control Code, any message will not
appear.
• If the unit and the Remote Control's Remote Control
Code does not match, an error Display message will
appear on the front panel:‘rc 1’ or ‘rc 2’ or ‘rc 3’.
If ‘rc 1’ is Displayed, you need to change the Remote
Control's Remote Control Code by keeping press
[ OK ]
and press
[ 1 ]
. If ‘rc 2’, press
[ OK ]
and
[ 2 ]
.If
‘rc 3’, press
[ OK ]
and
[ 3 ]
.
Note(s)
• You need to set both the unit and the Remote Control to
the same Code.
• The default setting for the Remote Control is “Code1”.
EN.indd 58
2015/09/02 19:01:06
