EN - 60
Channel Settings
Be sure the RF Cable is correctly connected to this unit and you
are Registered with your Cable Digital TV provider when you
install Cable Channels.
1
Press
[ HOME ]
then Select “Settings” using
[
K
/
L
/
0
/
1
]
then press
[ OK ]
.
2
Select “Channel Settings” using
[
K
/
L
]
then
press
[ OK ]
.
3
Select a desired item using
[
K
/
L
]
then
press
[ OK ]
.
4
Press
[ (EXIT) ]
to Exit.
Channel
1
Select “Channel” using
[
K
/
L
]
, then press
[ OK ]
.
Auto Channel Preset
If you Switch input signal wires (e.g. between Antenna and
CATV) or if you move the unit to a different area after the
Initial Setting or if you restore the DTV Channels you Deleted,
it is recommended to search a new Channel.
2
Select “Auto Channel Preset” using
[
K
/
L
]
,
then press
[ OK ]
.
• The password will be required if you have locked
Channels. Refer to ‘Channel Lock’ on page 62.
3
Select a desired item using
[
K
/
L
]
, then
press
[ OK ]
.
Antenna
Cable
To scan Digital Over-the-Air
Broadcasting.
To scan Digital Cable Broadcasting.
• Channel search will begin.
4
Press
[ OK ]
to complete Channel scan.
• Press
[ (EXIT) ]
to Exit.
Note(s)
• After setting “Auto Channel Preset”, using
[ CH +/
−
]
Skips unavailable Programs automatically.
• If you are not receiving a signal from your Cable service,
contact the Cable provider.
• If you Select “Back” by pressing
[ OK ]
during “Auto
Channel Preset”, the setup of TV Channels will be
canceled.
EN.indd 60
2015/09/02 19:01:07
