40
English
Troubleshooting
WARNING
Under no circumstances should you try to repair the system yourself, as this will
invalidate the warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, fi rst check the points listed below before taking the system for repair. If
you are unable to solve a problem by following these instructions, consult your dealer for
help.
No power.
No picture.
Completely distorted picture
or black/white picture.
No sound or distorted sound.
There is no sound from the
center and rear speakers.
– Check if the AC power cord is properly connected.
– Press the
2
(STANDBY ON) to turn on the power.
– Refer to your TV’s manual for correct Video In
channel selection. Change the TV channel until you
see the DVD screen.
– Press the DISC button to select disc mode.
– If this happens when you are turning on the
progressive scan feature, wait for 15 seconds for the
auto recovery.
– If this happens when you are changing the setting of
the ‘TV SYSTEM’, wait for 15 seconds for the auto
recovery.
– Check the video connection.
– Sometimes a small amount of picture distortion may
appear. This is not a malfunction.
– Clean the disc.
– Adjust the volume.
– Check the speaker connections and settings.
– Make sure that the audio cables are connected and
press the SOURCE button to select the correct input
source (for example, TUNER or TV/AUX/DI) to
choose the device that you want to hear through the
DVD system.
– When playback of DTS track, press
AUDIO
to select
other audio track.
– Make sure that the center and rear speakers are
connected correctly.
– Press the SURROUND button to select a correct
surround sound setting.
– Make sure that the source you are playing is recorded
or broadcast in surround sound (Dolby Digital, etc.).
Problem
(General)
Solution
