Magnavox MRU3300 - Universal Remote Control, User Manual

7

6

Direct Code Entry

1. Press and hold the 

CODE SEARCH

 button until the

red indicator stays on, then release the

 CODE

SEARCH

 button.

2. Press and release the desired mode button (

TV

,

VCR

, etc.). The red indicator blinks, then stays lit.

3. Enter the 4 digit code from the code tables (on

separate sheet). Note: after a valid code entry, the
red indicator turns off.  For an invalid code, the red
indicator flashes.

4. With your device on, press

 CHANNEL UP

. If the

device responds, no further programming is required.
Note: If some buttons do not operate your equipment,
try one of the other codes for your brand.

Write your codes down here for easy reference later.

Code Search

If your product does not respond after you have tried all
the codes for your brand, or if your brand is not listed,
try searching for your code by following these steps.

1. Manually turn on the device (

TV

, 

VCR

, etc.) to be

controlled.

2. Press and hold the 

CODE SEARCH

 button until the

red indicator stays on, then release the 

CODE

SEARCH 

button.

3. Press and quickly release the desired mode button

(

TV

, 

VCR

, etc.). The red indicator blinks off once.

4. Press the 

CHANNEL UP

 button repeatedly (up to

300 times) until the device to be controlled changes
channel. The red indicator blinks off with each
button press.  If you accidentally overshoot the
code required, press the 

CHANNEL DOWN 

button

to backtrack through the library until the device
changes channel. Pressing 

CHANNEL UP

 changes

direction to forward again.

5. Press and release 

MUTE 

to install the code.

Setup

Battery Installation

1. On the back of the remote,

push down on the tab and
lift the cover off.

2. Match the batteries to the

+ and - marks inside the
battery case, then insert 2
AAA Alkaline batteries.

3. Press the battery cover

back into place.

Battery Saver

Your remote automatically turns off if the buttons are
depressed more than 30 seconds. This will save your
batteries should your remote get stuck in a place where
the buttons remain depressed (e.g., between the sofa
cushions).

Code Saver

You will have up to 10 minutes to change the batteries
in your remote without losing codes you have
programmed. However, do not press any buttons until
batteries are installed in the remote. If buttons are
pressed without batteries in the remote, all codes will be
lost.

Power-On Default

The remote powers on in TV mode.

Code Setup

The 

CODE SEARCH

 button is used to setup the

remote. You can either setup the remote using the code
for your brand of product, from the code tables (on
separate sheet), or you can search through the library
of codes until you find a code that works for your
product.

Please refer to “Programming with Code Search” on page
7 for more information on using the code search feature
to learn how to search through the library of codes for
your products.

NOTE: You can store any kind of code under any mode
(except TV). I.E. you can store a VCR code under the

CBL 

button, or a DVD code under the 

VCR 

button, etc.

However, you can only store TV codes under the 

TV

button.

Type

Type stored

Code

TV

TV

VCR

Cable