SYSTEM INSTALLATION
4. Cut the antenna cable to the required length. Leave a little extra length to correct
any mistakes.
5. Install the F-type connector. Refer to Figure 3 for connector installation instructions.
CAUTION
Be sure that the center conductor ofthe cable comes through the connector and sticks out
beyond the connector surface at least 3/8-inch (1 cm). Otherwise, you won’t have a
dependable antenna connection.
6. Use a volt-ohmmeter to verify that no short circuit exists between the center
conductor and the shield of the coaxial connector after you attach it. You should
measure about 2-K ohms g 10% between the antenna connector and ground (shield).
GQIPIIB HG
{ 4.p{ {4— U (0-25)
‘— “*!
$2 (M8) ‘·P{
A®E"I'8 CABLE
OENTE OONHXZTOR
mo msuumou - ......... °‘° mm
IUTE: ALLDIMBIBIIJS III Il.I.IIlEI'ER8 AID IIOHEU
{ GOOD OGIIECIOR
1. unmeuuwmrmnnm {¤I•'{ { {
A FI.AT GMSS SECTION. I" ca I I
2. TRIM AID DRESS TIE CABLE T0 THE '
DIIEISIQIS SIKIIMI. D0 IDT NICK TIE l
BRAD OR CBGB OOIIJIDTOR.
& INET TIE EGE GOIDUGIOH AND {
N$l.I.A'I'DN INT0 'I'I·IE OGINECTOH A3 I {
FAR AS TIE GAB.! WILL @ (ALL OF I I I
BRAD SIKXID E GNEED BY TIE I I I
GONIEGTOR GFIPIJG RDR THE CENTER
eounucmn annum sncx our mom I I I
eounacmn AT Isur an new { { I
4. OECUE THE CARE TD THE IXIIIEGTOR
WITH A GILBERT ID.G-GRT-|5| OR AN
QIVALBIT ORIMPIII 'I'®I. {
I { I
Figure 3. Antenna ConnectorAssembly
7
